Safe-guard Cattle Deworming Block

25 lb

Block

One block treats 8,000 lb. (500 lb. of cattle per 1.5 lb.).

Adequate forage must be available at all times to cattle receiving supplemental block feeding.

Safe-Guard® (fenbendazole) ENPROAL® Molasses Block is designed for deworming pastured cattle by feeding these medicated blocks for three (3) days only as the sole source of salt.

It is essential to establish full cattle adaptation to supplemental block feeding prior to treating cattle with Safe-Guard® ENPROAL® Molasses Block. Cattle behavior and per capita consumption must be established by feeding nonmedicated ENPROAL® Blocks prior to medicated block treatment. Adaptation to block feed intake for medicated treatment may take twelve (12) to nineteen (19) days of prior exposure to unmedicated feed blocks depending on consumption rates and environmental conditions. When cattle block consumption of 0.1 pound (1.6 ounces) per 100 pounds of body weight (or 1.0 pound for a 1000-pound cow) per day is attained for several days on the nonmedicated ENPROAL® Block, the three (3) day medicated treatment with Safe-Guard® ENPROAL® Molasses Blocks may begin.

For effective treatment, the cattle must consume an average 0.1 pound of Safe-Guard® ENPROAL® Molasses Block per 100 pounds of body weight each day for three (3) days of treatment. This is equivalent to an average of one (1) pound per head per day to a 1000-pound cow for three (3) days of treatment in order to provide a total dose of 2.27 mg fenbendazole per pound of body weight.

To commence deworming treatment, replace the nonmedicated blocks with Safe-Guard® ENPROAL® Molasses Blocks. Place these medicated blocks at the same locations where cattle have demonstrated adequate per capita block intake (0.1 pound per 100 pounds of body weight per day).

DAILY TREATMENT (TO BE CONTINUED FOR THREE (3) DAYS ONLY):

 

Cattle Body Weight (Pounds)	Average Block Intake (lb/head/day)	Number of Head per Block*
500	1/2	16
750	3/4	11
1,000	1	8

 

*NUMBER OF HEAD FULLY TREATED BY EACH BLOCK WHEN CONSUMED IN THREE (3) DAYS.

Following the three (3) day treatment any remaining Safe-Guard® ENPROAL® Molasses Blocks should be removed from the pasture, and cattle may be returned to their normal supplemental feeding program. Remaining blocks, or portions of blocks, can be utilized for retreatment purposes if used prior to expiration date shown below.

It is essential that good block feeding husbandry practices be followed at all times. Block feeding techniques include, but are not limited to, a variety of practices. Blocks should first be located in those areas where cattle are seen to browse or loaf. It may be desirable to relocate unconsumed blocks to locations where obvious block consumption is identified. Increased consumption may often be obtained by moving feeding stations into shaded or loafing areas, closer to water source, increasing the number of blocks available to the animals or combinations of these practices. Decreased consumption may often be obtained by the reverse of the above practices.

Crude Protein	(min.)	4.75%
Crude Fat	(min.)	0.10%
Crude Fiber	(max.)	2.00%
Calcium (Ca)	(min.)	0.80%
Calcium (Ca)	(max.)	1.00%
Phosphorus (P)	(min.)	0.07%
Salt (NaCl)	(min.)	16.00%
Salt (NaCl)	(max.)	18.50%
Magnesium (Mg)	(min.)	3.00%
Fluorine (F)	(max.)	0.0002%
Ash Content	(max.)	38.00%

Cane Molasses, Salt, Cottonseed Meal, Magnesium Oxide, Ferrous Carbonate, Manganous Oxide, Zinc Oxide, Copper Sulfate, Calcium Carbonate, Calcium Iodate, Mineral Oil, Cobalt Sulfate.